Cross-polarization coupling in polarization maintaining fiber induced by periodic mechanical stress

One of the applications of polarization maintaining (PM) fibers is the creation of various sensors including level and hydrostatic pressure sensors. An external mechanical stress on a PM fiber causes cross-polarization coupling. In microand macro-bend pressure sensors, the attenuation of the optical signal increases with increasing external pressure. Combination of two physical principles in one sensor allows to create fiber-optic sensors of high sensitivity for operation at pressure more than 18 kPa. At the same time, the registration scheme is significantly simplified. An optical fiber with an elliptical ESC-4 stress cladding was used as a prototype. A superluminiscent diode ThorLabs S5FC1005SXL with a center wavelength of 1560 nm and a spectrum half-width of 45 nm was used in the study. In this work, the effect of induced periodic mechanical stress on cross-polarization coupling magnitude in a PM fiber with an elliptical stress cladding was considered. The induced periodic stress was generated by a proposed and specially fabricated periodic structure of optical fiber sections bonded to a glass substrate. The pressure on the fiber prototype was changed by weights of known mass as well as by rotating the fiber around its axis with a step of 5°. Hydrostatic pressure was created by means of a water tank placed in the barocamera. The cross-polarization coupled power was recorded with two photodetectors using a polarization beam splitter. It is shown that the largest value of the relative coupled power is achieved at the period of mechanical stress equal to the beat length of PM fiber. The dependence of the relative coupled power on the hydrostatic pressure is obtained for the prototype sensor. It is shown that the highest value of the relative coupled power is achieved at a pressure of 80 kPa. The threshold sensitivity amounted to 20 kPa. The decrease in coupled power at pressures greater than 80 kPa is attributed to induced optical losses. At pressure less than 20 kPa, a hysteresis of indicators up to 0.006 relative units is noticeable. A sample sensor for measuring hydrostatic pressure up to 80 kPa with the standard deviation of measurement results up to 7 % was obtained. The threshold sensitivity is limited to 20 kPa. The performed research can be applied in the development of fiber-optic pressure sensors.

1. Kaminow I.P. Polarization-maintaining fibers. Applied Scientific Research, 1984, vol. 41, no. 3-4, pp. 257–270. https://doi.org/10.1007/BF00382456

2. Hui R. Introducing to Fiber-Optic Communications. Academic Press, 2020. 659 p.

3. Fiber Optic Sensors. An Introduction for Engineers and Scientists. Ed. by E. Udd. Wiley, 2008, 520 p.

4. Okosi T., Okamoto K., Ocu M., Nisihara H., Kjuma K., Hatatje K. Fiber Optic Sensors. Leningrad, Jenergoatomizdat, 1991, 355 p. (in Russian)

5. Fraden J. Handbook of Modern Sensors. 3rd ed. Springer New-York, 2006, 589 p.

6. Lefèvre H. The Fiber-optic gyroscopes. 2nd ed. Artech House Publ., 2014, pp. 317–331.

7. Rashleigh S. Origins and control of polarization effects in singlemode fibers. Journal of Lightwave Technology, 1983, vol. 1, no. 2, pp. 312–331. https://doi.org/10.1109/jlt.1983.1072121

8. Skai J.I., Kimura T. Birefringence and polarization characteristics of single-mode fibers under elastic deformations. IEEE Journal of Quantum Electronics, 1981, vol. 17, no. 6, pp. 1041–1051. https://doi.org/10.1109/jqe.1981.1071213

9. Carrara S.L.A., Kim B.Y., Shaw H.J. Elasto-optic alignment of birefringent axes in polarization-holding optical fiber. Optics Letters, 1986, vol. 11, no. 7, pp. 470–472. https://doi.org/10.1364/ol.11.000470

10. Chinone N., Ulrich R. Elasto-optic polarization measurement in optical fiber. Optics Letters, 1981, vol. 6, no. 1, pp. 16–18. https://doi.org/10.1364/ol.6.000016

11. Liokumovich L.B. Polarization effects in fiber interferometers based on birefringent optical fiber waveguides. Dissertation for the degree of doctor of physical and mathematical sciences. St. Petersburg, SPbPU, 2008, 333 p. (in Russian)

12. Mukhtubaev A.B. The polarization cross-coupling influence on the Sagnac phase shift in a fiber-optic gyroscope. Academic dissertation сandidate of engineering. St. Petersburg, ITMO University, 2020, 199 p. (in Russian)

13. Yao X.S. Measurements of strain, stress and temperature by using 1-dimensional and 2-dimensional distributed fiber-optic sensors based on sensing by polarization maintaining fiber of distributed polarization crosstalk distribution. Patent US9476699, 2016.

14. He Z., Zhang Z., Feng T., Li Q., Yao X.S. Liquid pressure sensing system based on distributed polarization crosstalk analysis in polarization maintaining fiber. Optoelectronic Letters, 2022, vol. 18, no. 11, pp. 651–657. https://doi.org/10.1007/s11801-022-2072-z

15. Bureev S.V., Dukel’skij K.V., Eron’jan M.A. Method of making single-mode fibre-optical waveguides which retain radiation polarization. Patent RU2396580C1, 2010. (in Russian)

16. Aksarin S.M. Investigation of polarization methods and technologies for matching fiber-optic and integrated-optical waveguides. Dissertation for the degree of candidate of technical sciences. St. Petersburg, ITMO University, 2014, 116 p. (in Russian)